flingwinger
Advanced Member-
Posts
194 -
Joined
-
Days Won
15
flingwinger's Achievements
-
It’s far from a free for all unless you are referring to all the US aircraft operating up here under CUSMA. NCR 034-2022 describes the requirements for parts installation on an aircraft with a Special CofA, if you care to read up on it.
-
It’s only two jobs, one pay if you let it be. As a pilot/eng I’ve never been put in that situation, and don’t plan to. For what it’s worth, I also have never been laid off in this industry. Qualified engineers are seemingly hard to come by these days
-
I disagree. Now you can’t even have a single beer with dinner and there is nothing more satisfying than a cold beer after a 8-10 hour day sweating your bag off in the cockpit.
-
Here is what Rolls Royce requires Re: Start cycles, from the RR300 manual which is VERY cycle limited. TBO is 3000CYC or 2000HRS whichever comes first. Chapter 05-12-00 contains FAA approved life limitations for those engine parts that are life limited. Life limits of parts are based on total hours or total cycles, which ever occurs first. (1) Definition of an Engine Hour Operating hours with respect to maintenance records means the time from the moment an aircraft leaves the surface of the earth until it touches at the next point of landing. (2) Definition of an Engine Cycle A cycle is defined as a start or start attempt when fuel ignition occurred. The operator is required to keep a record of engine cycles
-
-
Ray beat me to it. And here is the Airframe Airworthiness limitations manual reference (in part) to cycle counting for landings. It does say FLIGHT HOURS (FH)= Takeoff to Landing
-
My experience is mostly on the French engines but referring to the Arriel 1D1 maintenance manual 05-10-00-200-801 - Airworthiness limitations it specifically states: Cycle counting does not take into account run-ups for maintenance purposes.
-
The manufacturers clearly define what is to be logged. Start cycles and ground runs for maintenance purposes are typically never logged unless the aircraft leaves the ground. The rest of that sounds pretty shady! Revenue, non-rev, Private doesn’t matter which, cycles, flight time etc are always counted. Now the flight time = air time debate is a different can of worms. I disagree completely that flight=airtime and I log them separate. Again following the manufacturers requirements for airtime = skids up to skids down. Flight time = blades turning to blades stopped.
-
Bose A20 Headset In A Helmet - Anyone Tried One?
flingwinger replied to opie's topic in General Helicopter Operations
They do offer this as an option now, although probably not cheaper than a DIY http://www.lightspeedaviation.com/content/lightspeedaviation/CustomPages/Zulu-H-Mod.htm -
I too was trained to be on the ground at 20gal and to be extra diligent to fly in trim at low fuel, like any aircraft. Anything below 20 GAL is pushing it imo. I’d rather have the fuel and not need it than need it and not have it. procedure is land as soon as possible with the fuel light if equipped, so why would you carry on below 20gal without the light? sorry about the accident. ****** situation.
-
This one? http://www.bst-tsb.gc.ca/eng/rapports-reports/aviation/2016/a16w0126/a16w0126.asp
-
I had a set that were made when I first purchased my gallet with the cep kit installed. I had to get the moulds taken at a hearing clinic then ship them to the manufacturer. They were terrible. Hard rubber, never fit quite right. I think the ear canals were too long and yes they would break the seal often. I found the cep foamies to be better. I then had a set re-made a few years ago by a local hearing aid company and they were much much better, softer silicone type earplugs and have no issues with the seal breaking.
-
Yes the helmet comms function normal without the cep plugs connected. I've been using cep's for about 6 years with custom moulded earplugs. I can't fly without now. I also had a couple of the cables break, and cep USA replaced them. I think they have a revised cable now as this one is more than 2 years old around 800 hours of use and no issues.