Jump to content
Sign in to follow this  
Fly_Guy

Need Egt Advice For 205A1 Please..

Recommended Posts

Hello Guys,

 

I don't have too much experience with an EGT Guage in the 205A-1 with a T53-17 engine, but I want to run some numbers by you while the aircraft is on the ground and in flight and see if these numbers are "normal" or if they seem high to anyone..??

 

The temperature here is +24'C OAT, and our maximum starting and T/O EGT is 672'C, and 654'C for maximum continuous. (As per the placard)

 

We were flying at 2000', 35 PSI, 96% N1, and 555'C on the EGT Guage..?? Normal?

 

The difference between ground idle and flight idle is only 20'C. 540'C at 100% and 520'C at 71%. Is this Normal or should there be a greater gap in between the two?

 

The aircraft is equipped with a start fuel switch, and upon reaching either 25% or 400'C when the switch is to be turned off, the EGT guage will momentarily stop and then increase with the start until the trigger is released, even with the start switch in the off position.

 

Also, flying at 7000', +25'C OAT, 9500lbs for a weight, the rotor rpm started to drop off very "slightly". Maybe 2% or less. I had always figured the -17 was more or less "un-toppable" and a guy had to be extremely high before you would start to loose rotor RPM.

 

Any help is greatly appreciated fella's... Thanks.

 

Fly_Guy

Share this post


Link to post
Share on other sites

Power check numbers are saying plus 40 to 45 consistently...

 

N1 at 7000' was 101.5%....

 

I will look into N1 topping. Pretty sure the engineer did set it past 105N1 but I will double check with him..

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...